Lull 944E-42 Service Manual - Manual (Page 147)

8-31 944E-42
Hydraulic System
5. Install the left front dash panel (7) and secure with
the five washers and capscrews.
6. Install the selector knob and secure with the
retaining nut.
7. Connect the drain hose to the top of the select valve.
8. Install the front dash panel (8) and lower dash
panel (9).
9. Check the routing of all hoses, wiring and tubing for
sharp bends or interference with any rotating
members, and install tie wraps and/or protective
conduit as required. Tighten all hose clamps.
10. Properly connect the batteries
11. Start the engine and run at approximately 1/3-1/2
throttle for about one minute without moving the
machine or operating any hydraulic functions.
12. Inspect for leaks and check the level of the hydraulic
fluid in the reservoir. Shut the engine OFF.
Note: Check for leaks and repair as required before
continuing. Add hydraulic fluid to the reservoir as
needed.
13. Wipe up any hydraulic fluid spillage in, on, near and
around the machine, work area and tools.
14. Close and secure the engine cover.
c. Steering Test
Refer to Section 8.4.1, “Hydraulic Pressures.”
1. Conduct a pressure check of the steering hydraulic
circuit.
2. Check each steering mode for proper function.
MU4651
8
9
7