Lull 944E-42 Service Manual - Manual (Page 56)

Boom
3-26 944E-42
8. Rapid boom pad wear. 1. Incorrect wear pad gap. 1. Check wear pad gaps and
correct as needed. Refer to
Section 3.5.2, “Wear Pad
Installation and Lubrication.”
2. Rapid cycle times with heavy
loads.
2. Reduce cycle times.
3. Contaminated, corroded or
rusted wear pad sliding
surfaces.
3. Remove contamination and/or
corrosion from wear pad sliding
surfaces and lubricate. If the
surfaces cannot be
reconditioned, replace the boom
section(s).
4. Operating in extremely dusty/
abrasive conditions.
4. Clean equipment frequently.
9. Auxiliary hydraulics will not
operate.
1. Auxiliary hydraulic system not
operating properly.
1. Refer to Section 8, “Hydraulic
System.”
10. Excessive chain wear. 1. Improper chain adjustment. 1. Adjust to correct tension. Refer
to Section 3.4.1, “Boom Chain
Inspection.”- Replace chains as
needed.
2. Chain sheave(s) not properly
lubricated.
2. Lubricate chain sheave. (Refer
to Section 2.5, “Service and
Maintenance Schedules.”
3. Chain sheave(s) not rotating
freely.
3. Lubricate chain sheave. Refer to
Section 2.5, “Service and
Maintenance Schedules.”
Repair or replace chain
sheave(s) as needed.
4. Improper chain lubrication. 4. Lubricate at regular intervals.
Refer to Section 2.5, “Service
and Maintenance Schedules.”
Replace chains as needed.
Boom Troubleshooting (Continued)
Problem Cause Remedy