Snorkel XT24SD-sn000001+ - Manual (Page 14)

1/31/2008 - 18 -
PRE-OPERATION CHECKLIST
DO NOT operate the machine with a low charge on the batteries, as indicated by
the low battery light on front of control box.
The scissors lift must be on firm ground.
The ground slope must not exceed 5 degrees.
Select the lift to operate in the ground position. Ensure the scissors lift is
operating as expected. If the scissors lift does not work as expected do not use.
Ensure people are clear of the machine, in particular the scissors mechanism has
potential pinch points, see warnings.
OPERATION OF SCISSORS LIFT
CONTROLS
The lift is equipped with a PLC (Programmable Logic Controller) that controls the
operations of the scissors lift and is located in the main control box in front of the
scissors lift. Servicing of these components should be performed only by trained
technicians.
The Control Panel
CONTROLLING FROM GROUND LEVEL
The controls are located in the front of the main control box located in the
front of the machine. (See diagram on page 22)
To operate the platform from the ground controls, turnkey switch to the
ground position.
Push the push to enable button while simultaneously twisting the raise/lower
platform button.