Snorkel XT24SD-sn000001+ - Manual (Page 28)

1/31/2008 - 32 -
 Check the tire surface and sidewalls for cuts, cracks, punctures and
unusual wear.
 Check each wheel for damage, bends, or cracks.
Other lubrication
Grease zerks are provided on both the top and bottom ends of the main
hydraulic cylinder. Lift the machine and place the safety prop in position in order
to grease these fittings.
Level sensor- Audible alarm
The level sensor is designed to give an audible signal at out of level attitudes
of 2 degrees front to back and 2 degrees side to side. The level sensor is pre-set
at the factory and it is leveled with the frame of the machine using three bracket
bolts with spring tension on them. Always level the machine to the frame using
both the indication level on the sensor and a four foot contractor‟s level.
Switches & Locations
Zero Height Switch- Used to stop machine a zero height. The switch is located at
the back of the machine in the lower right corner.
Top Stop Switch- Used to stop machine at 24 foot (7.3 meters) max height. The
switch is located at the middle of the machine in the lower left hand side.
Top Stop
Switch
Zero
Height
Switch
Zero
Height
Switch