Axcess Network Receiver Installation Guide - Manual (Page 11)

© 2002, AXCESS Inc. 750.001.005 R0000 11
Functions & Features
The Network Receiver has the following functions:
• Decode the signal received from the Tag via the receive antenna.
The Receiver converts the data to a format usable by a computer
or Wiegand control panel for further data processing
• Filter Tag information according to its configuration settings
• Send the data to a control device or a computer
• Output control signals for activating TTL outputs or alarm points
on panels
The Network Receiver has the following features:
Filters
The Receiver can be configured to report only selected Tag data. For
example, the Receiver can be programmed to respond to specific
Activators in a multi-Activator environment. Configuration filters also
determine speed of the information is reported via the Wiegand
interface.
Serial Output
The Receiver communicates using the EIA-232 standard, more
commonly known as RS-232C. It can connect to a communications
port on a computer or any device that accepts RS-232C data.
Wiegand Output
The Receiver can be configured to send Security Industry Association
(SIA) 26-bit Wiegand data to control panels. The Receiver connects to
the Wiegand port on the control panel by three wires – Data One,
Data Zero and Ground.
IP Output
The Receiver can be configured to connect to an IP Network. The
unit will need a static IP address