Axcess Network Receiver Installation Guide - Manual (Page 9)

© 2002, AXCESS Inc. 750.001.005 R0000 9
Required for Serial Output
•
A straight-through (one to one) RS-232 cable of sufficient length
to connect the Receiver to the system PC. It is recommended
that the cable not exceed 50 feet in length. One end of the cable
should be a male DB9 connector.
Required for Network Output
•
RJ-45 cable for connecting to the LAN
Recommended
•
Ladder
• Fishing line – 15 lb. test for pulling cable
• Tie wraps and anchors
• A pair of walkie-talkies if more than one installer will be
on site
• Laptop computer to connect to Receivers and Activators
easily
• Instructions for all third party devices