Axcess Network Receiver Installation Guide - Manual (Page 23)

© 2002, AXCESS Inc. 750.001.005 R0000 23
Figure 7 Enter the IP address and subnet mask
5. Click OK and follow the prompts .
NOTE It may be necessary to reboot your PC after making the
above changes.
6. Using a standard CAT5 Crossover cable (included),
connect directly from the Ethernet port on the back or
side of the PC to the RJ45 connector on the front of the
receiver (Figure 8).
CAT5 Crossover
Cable
To the Ethernet
Port of the PC
Network Receiver Front Panel
PWR LF
UHF
RX TX
DATA
RX TX Network Receiver
R
J
4
5
Figure 8 Connecting Crossover cable
7. On the PC, click Start > Programs > MS-DOS Prompt.