Axcess Network Receiver Installation Guide - Manual (Page 24)

Network Receiver
24 750.001.005 R04 © 2005 AXCESS Inc.
8. At the DOS window, type telnet 192.168.1.200
9. Login using the Username “ admin ”, and a Password of
“ welcome ” (Figure 9).
Figure 9 Login using “admin” and “welcome”
10. Type ipconfig and set the IP address and the subnet mask
(provided by the Network Administrator) for each Network
Receiver (Figure 10). For example, to set the IP address to
192.168.1.200 , the subnet mask to 255.255.255.0 and the
gateway to 192.168.1.1use the command: ipconfig –a
192.168.1.200 –m 255.255.255.0 –g 192.168.1.1
Figure 10 Set the IP address and subnet mask for each receiver
NOTE In Figure 10, notice that the IP address for the receiver is
different from the address for the PC being used to program it. A
typical scenario would be for the last three digits to increment by
one for each address.
The Set IP address ( -a ) command, the Set subnet mask ( -m )
and gateway ( -g )command must be used together (-g)
Refer to Appendix D for additional information regarding
ipconfig commands used to configure domain name, gateway
address, primary DNS address and other options .
Welcome