Axcess Network Receiver Installation Guide - Manual (Page 44)

Network Receiver
44 750.001.005 R04 © 2005 AXCESS Inc.
The following set of response codes are output by the Network Receiver to acknowledge
receipt and processing of configuration and control commands:
Response Description
00 Command completed successfully (ACK)
01 Duplicate Device ID (response for command <number>+)
02 Valid ID list full (response for command <number>+)
03 Valid ID list must contain at least one entry (response for command <number>-)
04 Device ID not found (response for command <number>-)
05 Invalid entry (response for <number> commands when value entered is not allowed)
06 Invalid command (response for an invalid or unknown command entry)
The following set of response codes are output by the Network Receiver to query and
supervisory commands:
Response Description
38c [Content: Device ID, Valid ID list, configuration settings/values; Format: Refer to the
installation section of this manual.]
40c [Content: Device ID, firmware version; Format: Refer to the installation section of this
manual]
The Following sets of output codes are output by the Network Receiver on a timed basis.
Response Description
* Character output once every minute via the RS-232 and TCP/IP ports to indicate the
receiver is still connected.