Axcess Network Receiver Installation Guide User Manual
Page 26
Network Receiver
26
750.001.005 R04
© 2005 AXCESS Inc.
IMPORTANT!
Note all previous settings as it will be necessary
to reset your PC after the Network Receiver is configured
.
4. Click on the Specify an IP Address option button and
enter
192.168.1.199
as the IP address and
255.255.255.0
as
the subnet mask
.
5. Click
OK
and follow the prompts
.
NOTE
It may be necessary to reboot your PC after making the
above changes.
6. Using a standard CAT5 cable (not included), connect
directly from the Ethernet port on the PC to an empty port
on a standard hub. The Ethernet port will be located on
the back or side of your PC, and is the connection to your
building network. Using another standard CAT5 cable
(not included), connect from the RJ45 connector on the
front of the Network Receiver (labeled RJ45) to an empty
port on the hub (Figure 12).
Hub
RJ-45 to RJ-45 cable
(Not supplied)
IP Receiver
4
5
R
J
Figure 12 Connecting to the network via a Hub
7. Continue as described in items 7 through 13 under
instructions for using a Crossover cable to connect to the
network.