Pressure test conduit – Condux Deluxe Blower User Manual
Page 17
17
Pressure Test Conduit
The conduit system must be able to withstand a maximum pressure of 175 psi, and
be free of leaks. A Conduit Pressure Test Kit, part number
08761457, is available to
perform this test. Conduit may also be tested for pressure using the Deluxe Blower,
follow the steps below.
1. Loosen the 6 nuts on the
Air Block assembly (Figure 20). Open the Conduit
Clamp Cover and Air Block Cover (Figure 21).
2. Select the correct Conduit and Cable Components according to conduit and
cable size. Refer to the Conduit and Cable Pack selection charts
(Tables 1 and 2, page 18).
3. Choose the correct
Conduit Seal and install both halves securely. (Figure 22).
4. Choose the correct
Conduit Clamp and install both halves (same color as the
conduit seal). (Figure 23).
Figure 20. Loosen Air
Block Assembly
Figure 21. Open Conduit Clamp
Cover & Air Block Cover
Figure 22. Install Conduit Seal
Figure 23. Install Conduit Clamp
7.