Condux Deluxe Blower - Manual (Page 5)

5
optic cable measuring from 1 ⁄
4
" to 1.13" (6 mm to 28.7 mm) into an unobstructed,
unoccupied, airtight conduit run at speeds of 0 to 300 feet per minute (0-91 m/min).
A cable carrier must be placed at the front end of the cable.
The Deluxe Blower greatly reduces pulling stress on the cable. When equipped with
the electronic counter box, the tractor drive will automatically shut down if the cable
hits an obstruction or if it begins to slip on the tractor drive.
The blower comes standard with job box, hydraulic hoses with couplings, digital
LCD electronic counter box, and an adjustable control valve to the tractor drive for
speed adjustment.
GENERAL mAChINE uSE
a. Only qualified operators should use the machine. The operator should only be
the person who received qualified training from the product owning company or
trained by the manufacturer.
b. Machine must only be used for the work it was designed for.
c. Machine is not to be used with unauthorized personnel on the job site.
d. Should there be any doubt concerning use, functioning, maintenance or
anything else, please contact the factory or factory representative.
OPERATOR QuALIFICATIONS
a. Operator must know the required safety directives to run the machine that are
pertinent to the country where it is being used.
b. Operator in charge of the machine and installation project must be appropriately
dressed, avoiding large clothes, hanging jewelry or whatever might become
entangled in the moving parts.
c. Operator must also wear the necessary protective equipment such as gloves,
boots, helmet, etc.
d. Operator must carefully follow all advisements contained in the instruction
manual or on the machine.
e. Operator must have work area kept clean of obstacles that might inhibit a safe
working area.
mAINTENANCE QuALIFICATION
a. All of the machine maintenance must be carried out with the machine on a level
surface and not attached to any form of power source: electrical, pneumatic, nor
hydraulic.
b. Authorized and trained personnel must do all maintenance operations. Trained
personnel are defined as people who have received qualified training from the
using company or from the manufacturer.