Condux Deluxe Blower - Manual (Page 38)

38
Tractor Feed does not pull the cable off
the reel.
Blower cuts out with electronic error or
highspeed error.
It is difficult to keep the cable moving
near the end of the conduit run.
The cable run is hard to restart after
having stopped.
Tractor feed doesn’t start.
Assist the reel by pushing it, and/or by pulling
the cable off the reel.
Blower has exceeded the maximum speed
allowance. Adjust speed accordingly, or wipe
cable clean from mud and dirt.
Assist the blower by manually pushing the
cable into the conduit.
Do not bend or crimp the cable.
Put air to the system with the track down. The
tractor feed can be restarted after the air
pressure has increased and stabilized.
1. Hydraulic flow control is at the lowest
speed-increase flow speed slowly.
2. Hydraulic “on”/”off” is in the “off”
position-rotate handle to the “on”
position.
3. Electronics is in the “stop” position-push the
“start” button.
4. “E-stop” is still in the active mode-rotate
clockwise to allow the button to reset.
5. Hydraulic power pack is in the “off”
position-turn it to the “on” position.
6. Check that the hydraulic hoses are
connected correctly.
Cable becomes jammed in the conduit
system. 1. Inform the people at the other end of
the conduit that a problem has been
experienced and the operator is going to
shut down the system.
2. Shut off the hydraulic valve at the blower.
3. Shut off the pneumatic air supply with the
Air Control Valve turning it to the 9 o’clock
position, allowing the air pressure to be
depressurized from the conduit and the air
block.
3. Using the counter or the measurement on
the cable, determine where the
blockage might be located.
5. Notify supervisor about problem and
determine a solution accordingly.
Problem Solution
14.
Troubleshooting Guide