Condux Deluxe Blower - Manual (Page 36)

36
Maintenance
CAuTION: Operators are not permitted to perform maintenance tasks
unless Condux personnel or representatives have appropriately trained
them. Disconnect the machine from its electrical, pneumatic, and
hydraulic power sources before servicing.
A. TRACk CLEANING AND TIGhTENING
1. Inspect track before and after each use.
2. Clean after each use, or when necessary. Remove the top assembly to clean
thoroughly by:
• Remove top capscrew with a 3 mm allen wrench and the flat washer on
clamp adjustment screw. This will allow for the top track assembly to be
unscrewed off the blower with the clamp adjustment (Reference Appendix K).
• Pressure wash if necessary
3. To compensate for normal belt stretching, there is a rubber dampening bushing
part number 08780028, which is lobed larger on one side than the other,
located at the pivot position of the idler skid part number 08780105. It is in the
smaller lobe position when it leaves the factory. If a tighter belt is needed,
rotate the bushing so the skid presses against the larger lobe. Be sure to have
both bushings in the same configuration before locking the skid back into
position. If this is not enough, then new tracks must be purchased (Reference
Appendix B & C).
B. REPLACEmENT OF ThE DRIVE BELT
The drive belt needs to be replaced when the machine is unable to tractor drive the
specified range of cable diameters. Only genuine spares should be used otherwise
the machine may be unsafe and void warranty (Reference Appendix B & C).
1. Remove the 2 capscrews which hold the sled in place with a 3 mm T-handled
allen wrench. This should allow the sled to rotate up.
Figure 77. maintenance Schedule
13.