ElmoMC SimplIQ Digital Servo Drives-Whi-Solo Installation Guide - Manual (Page 16)

Solo Whistle Installation Guide
MAN-SOLWHIIG (Ver. 1.503)
www.elmomc.com
16
Chapter 3: Installation
The Solo Whistle must be installed in a suitable environment and properly connected to its
voltage supplies and the motor.
3.1. Site Requirements
You can guarantee the safe operation of the Solo Whistle drive by ensuring that it is installed in
an appropriate environment.
Feature Value
Ambient operating temperature 0 °C to 40 °C (32 °F to 104 °F)
Maximum relative humidity 90% non-condensing
Operating area atmosphere No flammable gases or vapors permitted in area
Models for extended environmental conditions are available.
Caution:
The Solo Whistle drive dissipates heat by convection. The maximum operating
ambient temperature of 0 °C to 40 °C (32 °F to 104° F) must not be exceeded.
3.2. Unpacking the Drive
Before you begin working with the Solo Whistle, verify that you have all of the components, as
follows:
• The Solo Whistle servo drive
• The Composer software and software manual
The Solo Whistle is shipped in a cardboard box with Styrofoam protection.
To unpack the Solo Whistle:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Solo Whistle drive you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Solo Whistle.