ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide - Manual (Page 14)

Maestro Installation Guide Installation
MAN-MASIG (Ver 1.33)
3-4
3.2 Unpacking the Components
Before you begin working with the Maestro system, verify that you have all of its
components, as follows:
ƒ
The Maestro Multi-Axis Supervisor
ƒ Maestro software which may be downloaded from www.elmomc.com
The Maestro is shipped in a cardboard box with styrofoam protection.
To unpack the Maestro:
1. Carefully remove the Maestro from the box.
2. Check the Maestro to ensure that there is no visible damage to the instrument. If any
damage has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Maestro you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Maestro as shown below.
The P/N number at the top gives the type designation as follows:
M A S - 1 0 0 1 2 - 1 C
Communications:
1C = 1 CAN Ports
2C = 2 CAN Ports
No. of Axes
4. Verify that the Maestro type is the one that you ordered.
5. Verify that you have the correct number of CAN termination resistors (dongles), P/N:
ACC-TRM-01, illustrated below.
• For MAS-XXXX-1Y, two CAN termination resistors are included.
• For MAS-XXXX-2Y, four CAN termination resistors are included.