3 groups, 4 can inputs (i/o) – ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide User Manual
Page 34
Advertising
4.6.3
Groups
The groups are set up as follows:
1. Select a CAN bus.
2. Click the right mouse button.
3. Select Insert.
4. Select Group.
5. Select Group ID.
6. Give the group a name (such as Group).
7. Select a Type (Elmo or DS402).
8. From the list on the left-hand side, select the
object name and add or delete them using
the arrow-buttons.
9. Click OK.
10. Repeat for each of the other axes.
4.6.4
CAN Inputs (I/O)
The CAN Inputs are set up as follows:
Maestro Installation Guide
Maestro Software Setup
MAN-MASIG (Ver 1.33)
4-9
Advertising