5 d-sub cable assemblies – ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide User Manual
Page 20
3.5
D-sub Cable Assemblies
The Maestro features easy-to-use D-sub type connections for various cables. These cables are
available from Elmo. The instructions and diagrams below are designed to help customers
who wish to build their own cables.
Use 24, 26 or 28 AWG twisted-pair shielded cables (24 AWG cable is recommended). For
best results, the shield should have aluminum foil covered by copper braid.
Use only a D-sub connector with a metal housing.
Attach the braid shield tightly to the metal housing of the D-type connector.
On the device side, ground the shield.
Figure
3-5: I/O Cable Assemblies
Note: All D-sub type connectors used with the Maestro should be assembled in this way.
Metal Housing
Verify that the braid shield is in tight
contact with the metal housing
Maestro Installation Guide
Installation
MAN-MASIG (Ver 1.33)
3-10