ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide - Manual (Page 29)

4.3 Configuring the Maestro
Maestro can be connected in two ways:
ƒ Through a Network (with a DHCP server)
ƒ Peer-to-Peer
Ethernet Hub/Switch/Router
Std. Eth. Cable
Eth. Cro
ss Cabl
e
Figure 4-1 Maestro Connected to a Network Figure 4-2 Maestro Connected Peer-to-Peer to PC
4.3.1 DHCP Connection
When the Maestro is connecting to a network with a DHCP server, its IP address is
provided automatically. The Elmo Studio can be used to display that address.
To find the IP address select File/New/Workspace and enter a Workspace name.
After you click OK, the IP addresses of all the Maestros on the network will be displayed.
Maestro Installation Guide Maestro Software Setup
MAN-MASIG (Ver 1.33)
4-4