4 telnet terminal communications – ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide User Manual
Page 30
Advertising
4.4 Telnet Terminal Communications
When there are several Maestros connected to the LAN it’s a good idea to give each a
unique name. This is done through a Telnet connection as follows:
1. Select Start/Run in Windows.
2. Type Telnet and the I.P. address in the Open dialog.
3. Type name to see the current name of the Maestro at that address.
4. Type name followed by your name of choice.
5. Type name again to confirm that your name has been applied.
Maestro Installation Guide
Maestro Software Setup
MAN-MASIG (Ver 1.33)
4-5
Advertising