ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide - Manual (Page 6)

1.1 Cautions
The Maestro must be connected to an approved 24VDC power supply
through a line that is separated from hazardous line voltages using
reinforced or double insulation in accordance with approved safety
standards.
Before switching on the Maestro, verify that all safety precautions have
been observed and that the installation procedures in this manual have
been followed.
1.2 Directives and Standards
The Maestro conforms to the following industry safety standards:
Safety Standard Item
In compliance with UL60950-1
(formerly UL1950)
Safety of Information Technology Equipment,
Including Electrical Business Equipment
In compliance with EN60204-1 Low Voltage Directive, 73/23/EEC
The Maestro has been developed, produced, tested and documented in accordance with
the relevant standards. Elmo Motion Control is not responsible for any deviation from
the configuration and installation described in this documentation. Furthermore, Elmo is
not responsible for the performance of new measurements or ensuring that regulatory
requirements are met.
1.3 Warranty Information
The products covered in this manual are warranted to be free of defects in material and
workmanship and conform to the specifications stated either within this document or in
the product catalog description. The Maestro is warranted for a period of 12 months from
the time of installation, or 18 months from time of shipment, whichever comes first. No
other warranties, expressed or implied — and including a warranty of merchantability
and fitness for a particular purpose — extend beyond this warranty.
Maestro Installation Guide Safety Information
MAN-MASIG (Ver 1.33)
1-2