EZWatch Pro 1.1u - Manual (Page 12)

EZWatch Pro 11
© 2001-2002 Automated Video Systems
You can uninstall the driver by doing the following steps:
Step 1: Click "Start", "Settings", then the "Control Panel" icon.
Step 2: Select the "System" icon, then click it.
Step 3: Select the "Device Manager Properties", then click it.
Step 4: Select and click the "Sound, video and game controllers" icon, you will find out Security PCI 0
(PCI 1,
PCI 2, PCI 3) Device Video Server, then the Capture and Security PCI 0 (PCI 1, PCI 2, PCI 3)
device
Audio Server Capture. Click the "Remove" button to remove the driver.
Note: If the Video Server card is over one piece, please choose the right driver to match it.
Step 5: Click the "Ok" button to finish removing the device driver.
5 Using the EZWatch Pro software
5.1 Using the EZWatch Pro software
This topic discusses the EZWatch Pro software for general information.
Applies when you are located at a protected site where you have already installed the Video Server
Card with the
attached camera(s). At the local site, you can view video from the cameras as well as accept
remote user calls.
Once you have finished installing the software a new group and icons will be created for you. You may
access them
by clicking on the "Start" button and then "Programs", and finally click on the "EZWatch Pro" icon.
·
EZWatch Pro - The software enables you to remotely patrol your home, office, retail outlet,
warehouse, factory, etc.
This can be done from any place at any time as long as you have the access to
the phone line or Internet.
·
UnInstall Security System- Application to remove the EZWatch Pro software from the
computer.
·
EZBoot - You can set the system reboot schedule for Windows 98,Me,2K and XP.
·
Readme - User guide file that contains the installation and operation manual.
When you use the EZWatch Pro for the first time, you may have some problems like the ones shown
below:
A. The EZWatch Pro software is not able to execute after installation, and it shows the following error
message: