EZWatch Pro 1.1u - Manual (Page 27)

Using the EZWatch Pro software 26
© 2001-2002 Automated Video Systems
Note: The value of sensitivity depends on the installation place and light levels.
·
Delay: In order to avoid the fault alarm caused by a jump frame, you can set the image
tolerance. If your setting value is 2,
means that the change of three sequence frames will trigger the motion detection
function. By default this is set to 1.
·
After detection: When the image changes and triggers the " Motion Detection " function,
these videos will be saved into a file.
If the alteration time which stops from the last change and starts from the next
change is not over the set
time, then it will be also saved into the same file as the last one.
·
Setup motion schedule: Sets the time for a camera to start up the motion detection. Please
refer to " Setting up the schedule ".
Note: Be sure about the period you would like to execute the motion detection, since this function will
be available within this period.
·
Enable sound alarm: When motion detection starts up, the sound alarm will be enabled.
You can choose various sounds for
setting separate video cameras. There are four wave files in the
software as default, but you can also
select wave files from other folders. Before selecting them, you can play
them for confirmation. Please
refer to "
Setting up the sound alarm ".
·
Enable auto-link to remote site: Once motion detection is triggered, the videos recorded by
the local site will be transferred to
the remote site via the phone and the Internet. In the
meantime, the videos will be saved on
the set path in the remote site. In addition, the EZModem and
EZNetwork applications will
also inform the remote viewer and send the first trigger
picture on the remote screen.
Link: To time the period for hanging up after the video transmission from the local site to the
remote site.To set the "Auto-launch
to
remote site " function, follow these steps:
1. If you want to save a new remote site to auto-launch, please input the phone number or Ip address
into the number area.
2. Select the period that you would like to transmit, and input the number in the "Link" area.
3. After you finish the inputs, press the "Add" button. Your new phone number will be saved and
showed in the number dialog box.
Note: If you use the phone to notify the remote site, first you have to enable the modem (if external)
and the EZModem application in the remote site,
then you can get the automatic notifications. If you use the Internet to notify the remote site, both sites
(remote and
local) must have a static IP address and be available 24 hours. Meanwhile, the EZNetwork
application must be enabled in the
remote site, and then you can get the automatic notifications.
·
Enable phone notification: When motion detection is activated, the system will
automatically notify the set phone number.
Via the phone line, the receiver will hear whistles, if your modem
supports wave files.