EZWatch Pro 1.1u - Manual (Page 37)

Using the EZWatch Pro software 36
© 2001-2002 Automated Video Systems
Step1: On the screen, decide first the detection area, then move the mouse to its incipient spot and
click the left button
of the mouse. Keep dragging it, until the area is selected.
Step2: Click the "Add" button. After that, the screen will appear violet to mark the detection area.
Step3: If there is more than one area, please repeat steps 1 and 2.
Step4: Click the "OK" button to finish the settings.
Note: 1. Only changes that happen in the area set will activate the motion detection.
2. When motion detection is triggered, the video window of the opening camera will be selected
with a red frame. Double
click the left button of the mouse and then the red frame will disappear. This function can
remind the user not to enter
into the detection area.
Removing the detection area
Step1: Select the coordinate of the detection area that you would like to remove.
Step2: Press the "Delete" button and the violet mark will disappear.
Step3: Click the "OK" button to finish the settings.