KD Scientific Legato 130 Series User Manual
Page 31
31
Operating the KDS Legato 130
K
D
S
L
e
g
a
to
1
3
0
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 130 Syringe Pump User’s Manual
Publication 5617-008 Rev D
STEP-BY-STEP OPERATION EXAMPLE: USING A
CUSTOM PROGRAM
The following steps describe operation using a Custom
Program.
In the following description, we are assuming the use of a
Program that is already saved on the KDS Legato 130.
Note that if you make any changes to the Program’s
operating parameters and choose Accept on the page
where the changes are made, the changes automatically
become part of the stored Program for future use.
1.
From the Program Configuration screen,
the Program you wish to use should be displayed
in the Program Select button. If the Program is not
displayed, select the correct Program using the
procedure outlined in Running The Pump.
2. Choose the Syringe Select button to enter the
Syringe Selection screen.
3. Follow the instructions in the Syringe Selection
section of this Guide to complete the selection of a
syringe from the built-in syringe definition list, or to
create a new syringe definition. When finished,
choose the Accept button to save your changes, or
choose the Cancel button to cancel your changes,
and return to the Program Configuration screen.
4. Review the Pump Control Profile Steps described in
the Step Definition button. Note that the software
will display the first three Steps in the Program in
the main button area. If the Program uses more
than three Steps, the last Step in the Program will
be displayed in the box that is still part of the
button beneath the Step Definition button.
5. To review the Program Steps in detail or to
update/modify any of the stored Pump Control
Profile Parameters, choose the Step Definition button
to enter the Program Steps Summary Screen.
The name of the Program is listed at the right of the
screen, and the complete list of Steps is listed in a
series of buttons is on the left of the screen.
6. To review details for any individual Step in the
Program, select the Step you wish to review, then
press the Step button again to enter the Step
Definition screen for that Step.
7.
To edit the parameters for any Pump Control
Profile, follow the instructions supplied in the
applicable Pump Operation Profile description
contained in the Setting Program Parameters
section later in this Guide.
8. To return to the Program Steps Summary screen
when finished reviewing or editing the Step
parameter details, choose the Accept button to
save your changes or choose the Cancel button to
cancel any changes you made.
9. When you are finished reviewing the operating
details for all Steps, choose the Enter button to
return to the Program Configuration screen.
10. To preview the Program, choose the Preview
Program button, or to run the Program, choose the
Program Run button.
Step Definition Screen showing the list of Steps
currently defined for the Program
phone
508.429.6809
fax
508.893.0160
web
www.kdscientific.com