Lenze Function library LenzeIO1000Drv - Manual (Page 6)

Function library "LenzeIo1000Drv"
System requirements
6
L
DMS 1.0 EN - 07/2011 - TD05
2 System requirements
Software
The function library can be used with the following Lenze software:
Supported target systems
Required libraries for use in »Drive PLC Developer Studio«
with Drive PLC/9300 Servo PLC/ECS:
Unless already available, insert the following libraries into the library management (menu
WindowLibrary management):
 CANopenSdoDrvV10.lib
 LenzeTICan9300V10.lib
 LenzeIo1000DrvV10.lib
 LenzeConversionBoxV10.lib (optional)
Product Type designation Version
Drive PLC Developer Studio ESP-DDS2-x 2.x
PLC Designer V2 2.2 or higher
PLC Designer V3 ESPEVPDxxxxxx 3.x
Product range Type designation Hardware version From software version
Drive PLC EPL-10200 1A or higher 2.x
9300 Servo PLC EVS93xx-EI
EVS93xx-ET
2M or higher 2.x
ECS ECSxA 1B or higher 7.x
9400 ServoPLC E94AxPExxxx 2A or higher 2.x

Note!
Before the "LenzeTICan9300V10.lib" library is inserted into the library manager,
the CAN_Management system block must be implemented into the Control
configuration.
If the CAN_Management system block is missing or implemented subsequently,
a compilation error may be caused during the project compilation.
Remedy: Remove "LenzeTICan9300V10.lib" library from the library manager,
implement the CAN_Management system block and re-insert the library into
the library manager.