Lenze PC-based Automation Industrial PC - Manual (Page 103)

2.5 EN - 01/2012
L
103
Industrial PC | Parameter setting & configuration
Visualisation with »VisiWinNET®«
Introduction to »VisiWinNET®«
13 Visualisation with »VisiWinNET®«
This chapter provides information on the »VisiWinNET®« software. Apart from some
general information, it basically gives an overview of how the software is connected to
Lenze's control technology.
13.1 Introduction to »VisiWinNET®«
»VisiWinNET®« is a visualisation platform for mechanical and systems engineering.
 It can be used to create complex visualisation applications, the possibilities range from
classical operate and monitor functions through to sophisticated SCADA systems.
»VisiWinNET®« consists of a developer software and a runtime component.
 The developer software is used to create visualisation applications on the Engineering
PC which are run using the runtime component on the IPC.
 In order to transfer the visualisation applications created by means of the Engineering
PC to the Industrial PC, the »VisiWinNET®« Remote Access Manager software is used.
TCP/IP is used as a transmission standard.
13.1.1 »VisiWinNET®« Compact
»VisiWinNET®« Compact is a runtime version of »VisiWinNET®« especially designed for use
on computer systems. »VisiWinNET®« Compact requires very little memory capacity and
processor power. A version for the Windows® CE operating system and a version for
Windows® XP embedded are available. Detailed information on the installation and use of
»VisiWinNET®« COMPACT can be found in the manufacturer's original documentation.

Further information on the operation of »VisiWinNET®« can be found in the
software documentation of »VisiWinNET®«.