Lenze PC-based Automation Industrial PC - Manual (Page 125)

2.5 EN - 01/2012
L
125
Industrial PC | Parameter setting & configuration
Parameter reference
Structure of the parameter description
14 Parameter reference
This chapter lists all parameters of the Industrial PC and the extension modules in
numerically ascending order. The parameters of a Lenze device are called codes. Each code
can further be divided into subcodes.
Depending on the configuration and assembly of your Industrial PC, the parameter lists
may vary.
This chapter contains the following parameters:
Parameters of the standard device of the Industrial PC: Parameters of standard devices
( 129)
 Ethernet interface (on board)
( 153)

Panel
( 155)
 PLC (Logic/Motion)
( 159)
Extension modules of the Industrial PC: Industrial PC extension modules
( 161)

CAN communication card (MC-CAN2)
( 162)
 EtherCAT communication card (MC-ETC)
( 172)
 PROFIBUS master communication card (MC-PBM)
( 207)
 Ethernet communication card (MC-ETH)
( 209)
14.1 Structure of the parameter description
Each parameter is described in the parameter list in the form of a table which consists of
the following three areas:
Table header
The table header contains the following general information:
 Parameter number (Cxxxxx)
 Parameter name
(Display text in the »Engineer« or in the web-based parameterisation)
 Data types
 Decimal and hexadecimal parameter index for access via bus systems
Table contents
The table contains further general explanations and notes on the parameter and the
possible settings. The representation depends on the parameter type:
 Parameters with read access
( 126)
 Parameters with write access
( 126)