Lenze PC-based Automation Industrial PC - Manual (Page 41)

2.5 EN - 01/2012
L
41
Industrial PC | Parameter setting & configuration
Parameterisation using the L-force »Engineer«
Parameter reference
6.2.2 Saving data permanently
Code 18 enables you to transmit commands. A command overview can be found in the
description of code 18 of the parameter lists.
Via the Persist all command you can permanently save the changes carried out with an
online connection.
– The complete changes since the last restart of the Industrial PC are persistent.
The Industrial PC stores the data saved manually by the user on the CF card. For the project
management within the Industrial PC, different device commands are available, which can
be activated via code 18.
 When an online connection has been established, you can use the »Engineer« to
activate a device command by selecting it from the Device commands tab in C00018.
6.3 Parameter reference
 The codes are numbered and marked in the documentation by a "C" in front of the code,
e.g. "C00002".
 For the sake of clarity, some codes contain "subcodes" for storing parameters. This
documentation uses a slash "/" as a separator between code and subcode, e.g.
"C00118/3".
 The All parameters tab shows all available codes for parameterising the Industrial PC.