Lenze PC-based Automation Industrial PC - Manual (Page 30)

Industrial PC | Parameter setting & configuration
Commissioning
Configuring the Industrial PC
30
L
2.5 EN - 01/2012
The preset IP configurations can be configured using the »Engineer« and »WebConfig«.
 Entering the IP address of the Industrial PC
( 32)
4.5 Configuring the Industrial PC
This chapter will inform you on how to configure the Industrial PC during initial
commissioning. The configuration of the IP address and the touch calibration are
maintained when the system is restarted.

Note!
• The Industrial PCs are preconfiured, i.e. during initial commissioning the
touch display is already calibrated and a default IP address (192.168.5.99) is
defined.
• After 15 seconds the network configuration and the touch calibration are
closed automatically, and the Industrial PC continues to boot.