Schwank STW-JZ1 - Manual (Page 16)

16
STW-JZ / IW I&O Manual
IM101229
RL: 12A- BA
RD: DEC 2010
#11/A
Suspend with 3 chains in horizontal posi-
tion and continue installing the tubes and
reflectors to complete the system.
#11/B
When hanging a heater with a 180° el-
bow kit at 45° angle the vent run tubes
must be on top, with the burner on the
lower side.
JS-0504-JZ REFLECTOR ANGLE ADAPTER -JZ SERIES
1. A reflector angle adapter can be
installed on either side or both
sides of an elbow, depending
upon site requirements for an-
gling of reflectors
2. The angle adapter is installed on
the ‘flat’ side of the webbed
hanger (concave side of hanger
must face inward towards the el-
bow)
3. Rotate the angle adapter around
the tube to the desired angle of
the reflector - established by the
tube/reflector system hangers lo-
cated before or after the elbow
4. Align one of the holes in the angle adapter with the hole at top center of the elbow/tube
hanger
5. Bolt the angle adapter to the elbow/tube hanger through the aligned holes
6. The angle adapter will remain in place by resting on the tube
7. Attach reflector to the angle adapter with sheet metal screws
5
7
BURNER ON
LOWER SIDE