Schwank STW-JZ1 - Manual (Page 26)

26
STW-JZ / IW I&O Manual
IM101229
RL: 12A- BA
RD: DEC 2010
NOTE: Except for the vent end plate hanger, all hangers must be installed with the cavity side
facing the burner end of the system - the cavity side of the vent end hanger must face
the vent
1
1
FIGURE 16 REFLECTOR EXTENSIONS (OPTIONAL - IF REQUIRED )
1. Reflector extensions may be installed on
one side or both sides of the reflector
2. Reflector extensions are 116” (295 cm)
long
3. Holes (3) for “S” hooks are located
2.25” (5.7 cm) from each end and one at
the center of the reflector extension
4. Drill 1/4” (7 mm) holes in the reflector
3/4” (2 cm) up from the bottom edge of
the reflector to align with the 3 holes in
the top of the reflector extension
Reflector extensions
may be installed one
or both sides
Insert ‘S’
hook from
top and
rotate
10”
25 cm
5. Insert “S” hook down through hole in the top of the reflector extension
6. Rotate “S” hook approx. 90°, and insert into hole in reflector
7. Settle reflector extension into place