Rockwell Automation 1395 DC Drive, 800-1250 Hp, FRN 5.XX-9.30 - Manual (Page 160)

Chapter 5
Programming Parameters
5-69
Parameter 780 – 1395 Version Number [1395 Version No]
Internal units : None
Programming Terminal units: None
Description: This non-changeable parameter specifies the current
firmware version number on the Main Control Board, comprising the
VP, SP and CP.
Parameter 840 – SP Indirect 1 [SP Indirect 1]
Internal units : None
Programming Terminal units: None
Minimum Value: –32767
Maximum Value: +32767
Default Value: 0
Description: When programmed, appears as a constant Source
parameter value at parameter 10, and can be linked to a Sink
parameter.
Parameter 841 – SP Indirect 2 [SP Indirect 2]
Internal units : None
Programming Terminal units: None
Minimum Value: –32767
Maximum Value: +32767
Default Value: 0
Description: When programmed, appears as a constant Source
parameter value at parameter 11, and can be linked to a Sink
parameter.
Parameter 842 – SP Indirect 3 [SP Indirect 3]
Internal units : None
Programming Terminal units: None
Minimum Value: –32767
Maximum Value: +32767
Default Value: 0
Description: When programmed, appears as a constant Source
parameter value at parameter 12 and can be linked to a Sink
parameter.
Parameter 843 – SP Indirect 4 [SP Indirect 4]
Internal units : None
Programming Terminal units: None
Minimum Value: –32767
Maximum Value: +32767
Default Value: 0
Description: When programmed, appears as a constant Source
parameter value at parameter 13 and can be linked to a Sink
parameter.