Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM - Manual (Page 28)

18 Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014
Chapter 4 Install Your Module
4. Line up the small notch on the switch with the number setting you wish to
use.
Valid settings range from 001…254.
5. Replace switch dust caps. Make sure not to over tighten.
6. Reapply power.
Mount the Module To mount the module on a wall or panel, use the screw holes provided in the
module. Refer to the drilling dimensions illustration to guide you in mounting
the module.
Install the mounting base as follows:
1. Lay out the required points as shown above in the drilling dimension
drawing.
19.8
(0.78)
166.5 (6.56)
27 (1.06)
Side Mounting
32 (1.26 )
43.3 (1.70)
Front Mounting
18 (0.71)
37 (1.46)
16.2 (0.64)
168.6 (6.64)
179 (7.05)
45765
Millimeters
(Inches)
Functional Earth
Grounds the I/O block
EtherNet/IP communication
circuitry which is designed to
mitigate the effect of noise on
the network. It requires a solid
earth ground connection,
either through a metal screw
to a grounded metal panel or
through a wire.