Access module data in rslogix 5000 software – Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM User Manual
Page 55
Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014
45
Configure the Module Using RSLogix 5000 Software Chapter 6
Access Module Data in
RSLogix 5000 Software
Use the following information to use the 1732E-IB8M8SOER, 1732E-
OB8M8SR data in the ladder logic program.
Use the controller tags in your ladder program to read input data or write output
data.
The Port Configuration screen is grayed out
unless you are online with the controller and
module. On this screen, you can:
A. Enable or disable external ports.
B. Select Auto-negotiate on enabled ports.
If Auto-negotiate is disabled then select
the correct speed and duplex.
C. Click Port Diagnostics to display the Port
Diagnostics dialog.
D. If you make changes in Step A or Step B
then click Set. Changes will not take
effect until you reset the module or
cycle the power to the module.
E. Click the Network tab to see the next
screen, or
F. Click OK to close the Module Properties
dialog and download your configuration.