Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM - Manual (Page 30)

20 Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014
Chapter 4 Install Your Module
Pico-style 3-Pin Output Female Connector
Ethernet Connectors
Refer to the pinout diagrams for the network connectors
.
.
Power Connectors
Attach the mini-style 4-pin connector to the mini-style 4-pin receptacle as shown
below.
ATTENTION: Sensors/actuators power should not be
supplied externally.
IMPORTANT Use the 1585D–M4DC–H: Polyamide small body unshielded mating
connectors for the D-Code M12 female network connector.
Note that the distance between the center of each Ethernet
connector is 16.2 mm (see dimensions on page 18).
Rockwell Automation recommends the use of suitable cable based
on this measurement. Some of the recommended cables are 1585D-
M4TBJM-x and 1585D-M4TBDM-x for daisychains.
IMPORTANT Use two twisted pair CAT5E UTP or STP cable.
ATTENTION: Make sure all connectors and caps are securely
tightened to properly seal the connections against leaks and maintain
IP enclosure type requirements.
43583
(View into connector)
Pin 1 Sensor Source Voltage
Pin 3 Return
Pin 4 Output
(View into connector)
Pin 1Tx+
Pin 2 Rx+
Pin 3 Tx-
Pin 4 Rx-
Pin 5 Shell
4
2
3 1
5
44808
D-Code
M12 Pin
Wire Color Signal 8-way Modular
RJ45 Pin
1 White-Orange TX+ 1
2 White-Green RX+ 3
3 Orange TX- 2
4 Green RX- 6