Install the removable terminal block, Install the removable terminal block -5 – Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual User Manual
Page 13
Publication 1734-UM007D-EN-P - December 2005
Install the Module 1-5
Install the Removable
Terminal Block
A removable terminal block comes with your mounting base
assembly.
To remove, pull up on the RTB handle. This lets you remove and
replace the base as necessary without removing any of the wiring.
To reinsert the removable terminal block, proceed as follows.
1. Insert the RTB end opposite the handle into the base unit,
noting that the end has a curved section that engages with the
mounting base.
2. Rotate the terminal block into the mounting base until it locks
itself in place.
3. If an I/O module is installed, snap the RTB handle into place on
the module.
WARNING
When you connect or disconnect the removable
terminal block (RTB) with field-side power applied,
an electrical arc can occur. This could cause an
explosion in hazardous location installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
Hook the RTB end into
the mounting base end,
and rotate until it locks
into place.
44011