Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual - Manual (Page 40)

Publication 1734-UM007D-EN-P - December 2005
A-2 Configure Modules in RSLogix 5000 Software
When you change Connection and Data Format, note the following.
• You do not delete the existing module.
• You do not create a new module.
• You bring forward all possible configuration data for the new
setting.
• Configuration data that you cannot bring forward sets to the
default value.
Once you apply new settings, this becomes the base configuration for
the next change in Connection and Data Format settings. When you
select Apply, you lose all configuration data from previous data
formats.
Configure Your Module To configure your module in RSLogix 5000 software, complete the
following.
1. Configure your adapter.
Refer to the user manual for your adapter for information on
how to configure the adapter and add modules to the I/O
configuration to include selecting a controller and
communication module.
2. Add a 1734-SSI specialty module, according to the instructions in
your adapter user manual.
3. From the General dialog, access the following by clicking at the
top of the dialog, completing the entries as explained in this
chapter.
• Feedback
• Conversion
• Input Registration
• Watch Position
Use the Help Button Click Help at the bottom of the dialogs described in this chapter for
information about how to complete entries on the dialogs.
From a warning dialog, click Help at the bottom of the dialog to get
information about that specific error.