Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual - Manual (Page 21)

Publication 1734-UM007D-EN-P - December 2005
Configure the Module 2-5
Check I/O Status and View
the EDS File You can view the I/O defaults setup, and the EDS file by clicking the
appropriate tab.
To configure your module,
select Configuration and
modify the parameters as
desired for your application.
When complete, download to
your module by clicking the
Download to Device button.
You can download each
change as you make it using
Single, or download all your
changes using All.
Click here when finished.
Click the I/O Data tab to display the
default characteristics for this module.
This dialog shows the input/output defaults
for the four modes. These are:
Strobe
Polled
Change of state
Cyclic