Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual - Manual (Page 46)

Publication 1734-UM007D-EN-P - December 2005
A-8 Configure Modules in RSLogix 5000 Software
2. From the Watch Position dialog, make entries for Automatic or
Manual mode, refering to the table and noting the following.
• For Automatic mode for Comparator Control 0 and 1, leave
the value as Not Active and complete the entries for
Comparator Value 0 and 1.
• For Manual mode, click a value for Comparator Control 0 and
1 and complete entries for Comparator Value 0 and 1, noting
that in the figure the value shows Up Direction for
Comparator Control 0.
3. Perform one of the following.
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs
and continue to display the dialog, noting that you enable the
Apply button when you make changes to any of the dialogs.
or
• Click another tab at the top of dialog.
Comparator Control 0 and 1 Comparator Value 0 and 1
Automatic Manual Automatic Manual
Not Active Not Active
Up Direction
Down Direction
Both Directions 0…4294967295
with a default of 0