Work with the input registration dialog – Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual User Manual
Page 44
Publication 1734-UM007D-EN-P - December 2005
A-6 Configure Modules in RSLogix 5000 Software
Work with the Input
Registration Dialog
Follow these procedures to complete the Input Registration dialog.
1. From the General dialog, click Input Registration to display the
dialog.
2. From the Input Registration dialog for Input Latch select one of
these, with Off being the default.
• Off
• Off-to-On
• On-to-Off
• Both Edges
3. From the Input Registration dialog, complete one of these.
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs
and continue to display the dialog, noting that you enable the
Apply button when you make changes to any of the dialogs.
or
• Click another tab at the top of dialog.