Set the encoder’s parameters, Set the encoder’s parameters -3 – Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual User Manual
Page 19
Advertising
Publication 1734-UM007D-EN-P - December 2005
Configure the Module 2-3
Set the Encoder’s
Parameters
After adding the module to the network, you must configure the
module for use.
1. Configure the modules as shown in the figure.
You see a dialog with a series of tabs. Each tab provides options
to view or edit.
IMPORTANT
This chapter shows configuration in the online
mode. Changes set in this mode take effect when
you download to the individual module.
1. Click the module to
highlight it.
2. From the Device menu,
choose Properties.
You can also right-click the module or name,
and the property dialog pops up.
These are the tabs you click to
view the options.
Advertising