Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual - Manual (Page 43)

Publication 1734-UM007D-EN-P - December 2005
Configure Modules in RSLogix 5000 Software A-5
3. From the Conversion dialog, complete one of these.
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs
and continue to display the dialog, noting that you enable the
Apply button when you make changes to any of the dialogs.
or
• Click another tab at the top of dialog.
For more information on these parameters, refer to the definitions in
Chapter 4 of this publication.
For Select Comments
Gray-to-Binary
Convert Click the
checkbox Default is no Gray-to-binary convert with the
checkbox not checked.
Standardization Click the
checkbox Default is no standardization with the checkbox not
checked.
Trailing Bits 0…16 When you check Standardization, Trailing Bits is
selectable.
Default is 0.
Sensor
Resolution 1…65535 Default is 1.
Sensor Cycles 1…65535 Default is 1.