Rockwell Automation 1734-APB Point I/O Profibus Adapter Module - Manual (Page 13)

Publication 1734-UM005B-EN-P - June 2001
What is the PROFIBUS Adapter 1-3
Configure the Adapter for PROFIBUS Communication
•
Install the GSD file you received into your configuration tool
•
add the adapter to your configuration
•
select the node address and baud rate
•
add I/O modules to the configuration
For more information, refer to Chapter 3 - Configuring the POINT I/O
System.
Configure the I/O Modules for PointBus Communication
You must configure each I/O module to establish its actions on the
PointBus. Each module has a set of parameters that can be set (i.e.
Idle value, Fault value, etc.).
For more information, refer to Chapter 3 - Configuring the POINT I/O
System.
Adapter
Status
PROFIBUS
Status
PointBus
Status
1734-APB
Field
Power
System
Power
CHAS GND
NC
Node Address
Thumbweel
NC = No Connection
CHAS GND = Chassis Ground
C = Common
V = Supply
Profibus
Connector
NC
C C
V V
CHAS GND
System Power
Field Power
Adapter Status
PROFIBUS Status
PointBus Status
0 1