Rockwell Automation 1734-APB Point I/O Profibus Adapter Module - Manual (Page 34)

Publication 1734-UM005B-EN-P - June 2001
3-10 Configuring the POINT I/O System
Enable/Disable Diagnostic Functionality for your Modules
The diagnostic functionality is enabled at default, but may be turned
off (disabled) at the module level. When the diagnostic is disabled,
the module will not report any diagnostic information to the adapter.
Refer to chapter 4 for more information on module diagnostics.
Configure Fault Action/Value for your Output Modules
When communication between master and adapter is lost, the adapter
puts all connected I/O modules in their Fault state.
Module parameters
Select the “Extended
Diagnostics” parameter.
(Click on “OK” to
continue.)
Select “Enable” to enable
and “Disable” to disable
the diagnostic
functionality of an I/O
module.
(Click on “OK” to
continue.)
Module parameters
Select the “Fault Action”
parameter.
(Click on “OK” to continue.)
Select the desired state.
Possible settings are “Fault
Value,” and “Hold Last State
(HLS).
(Click on “OK” to continue.)