4 - module configuration, Dip switches, Chapter 4 – Rockwell Automation 1747-DCM,D17476.8 Direct Communication Module User Manual
Page 31: Module configuration, Chapter, Dip switch 1 settings
Advertising
4
Chapter
4–1
Module Configuration
This chapter provides DIP switch setting information for the DCM. Topics
include:
•
DIP switches
•
DIP switch 1 settings
•
DIP switch 2 settings
To configure the DCM for your application, you must set the DIP switches.
These switches enable the DCM to properly interpret the RIO system
addressing. The DCM has two banks of DIP switches mounted on its circuit
board. Each bank contains eight switches. The default settings are shown
below.
SW1
DIP Switch 1
(SW1)
SW2
DIP Switch 2
(SW2)
Reserved
Rack Size
Last Rack
Clear On Fault
8
O
N
12
3
4
5
6
7
SW1
Starting I/O Group Number
Rack Address
O
N
SW2
Data Rate
1
2
3
4
567
8
8
12
3
4
5
6
7
1
2
34567
8
DIP Switches
Advertising