Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 118)

Publication 2706-UM016D-EN-P - March 2006
4-52 InView Protocol
ASCII Characters You can enter extended ASCII characters directly within the text of a
message. Some of the characters may not show up depending on the
fonts on your PC. Please refer to the software help, 2706-PSW1, for a
complete listing of the extended ASCII character set.
Reference Material For additional information refer to, Modicon Modbus Protocol
Reference Guide, PI-MBUS-300 Rev C.
Valid Modes Used in P44 Series Displays
P44 Series
Display
Position Description
Top Displays text on top line only.
Bottom Displays text on the bottom line only.
Middle Used to display full height text (Fancy 16 Pixel or 16 Pixel).
Fill Displays two lines of 7 pixel characters.
Valid Modes Used in P72 Series Displays
P72 Series
Display
Position Description Comment 1 Comment 2
Top Displays text on top line
only. If the top line only has one row of text,
the remaining bottom rows are
considered bottom. If the top line only has two rows of text, the
remaining bottom row is considered bottom.
Bottom Displays text on the bottom
line only. If the bottom line only has one row of
text, the remaining top rows are
considered top. If the bottom line has two rows of text, the
remaining top row is considered top.
Middle Not used Not used Not used
Fill Displays full screen of text. Can be used to display Fancy 16 Pixel
or 16 Pixel characters.
TIP
You must preview your message to view the
extended characters when using the InView
Messaging Software.