Use an slc 5/03, 5/04, or 5/05 out channel zero, Use an slc 5/03, 5/04, or 5/05 out channel zero -2 – Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual User Manual
Page 62
Advertising
Publication 2706-UM016D-EN-P - March 2006
3-2 Serial ASCII Communications
Use an SLC 5/03, 5/04, or
5/05 out Channel Zero
The SLC processor is set up very similar to the PLC processor. The SLC
processor uses the same ladder logic as the PLC processor shown
below.
To use an SLC processor out Channel Zero on a display:
1. Create the new application and then set up the channel
configuration as shown.
2. Under the general tab make sure the mode for channel 0 is set
to USER.
ER
0
B3:0
EN
DN
ASCII Write
Channel
0
String Length
0<
Characters Sent
0<
Source
ST9:0
Control
R6:0
0
AWT
1
(End)
Advertising