Rockwell Automation 2085 Micro800 Discrete and Analog Expansion I/O Modules - Manual (Page 37)

Rockwell Automation Publication 2080-UM003A-EN-E - March 2013 29
Chapter
5
Configure Your Expansion I/O Module
Overview The following sample project guides you through the step-by-step process of
adding, configuring, deleting, and replacing Micro800 expansion I/O modules in
Connected Components Workbench.
In this sample project, you need to create a Connected Components Workbench
project with a 2080-LC50-24QWB controller. Then, configure four expansion
I/O devices (2085-IF4, 2085-IQ32T, 2085-OB16, 2085-IRT4) following the
instructions below.
These instructions make use of the drag-and-drop mechanism available in
Connected Components Workbench release 2 and higher, which allows the user
to easily add, replace, and delete devices through simple drag-and-drop motion.
Add an Expansion I/O
To add Expansion I/O modules to an existing Micro850 controller project, do
the following:
1. On the Project organizer pane, right-click Micro850 and choose Open.
TIP For more information about using the Connected Components
Workbench software, you can refer to the Connected Components
Workbench Online Help (it comes with your software).
TIP Expansion I/O modules are automatically added to a project when using
the "Discover" feature in Connected Components Workbench.