Brady 3481 - Manual (Page 24)

14
3.1 Loading Media
Begin loading as follows:
ΠRaise the Access Cover.
• Rotate the Printhead Latch forward and raise the Printhead Assembly.
Ž Slide the Media Guide out away from the frame and then lower it to the
down position.
• If using roll media, the Media Hub can accept 3.0-inch (76mm) and 1.5-
inch (38mm) cores. To use 1.5-inch cores, first slide off the 3 Inch Hub by
grasping and then pulling it firmly outward.
• Proceed according to the type of media you are using: either go to Section
3.1.1 for Roll Media or go to Section 3.1.2 for Fan-Fold Media.